Worth Data LZ404-RF Guia de Configuração descarregar pdf (Página 12)

Using The 1D RF Laser Setup Menu

Note: If you are using the 2D 520-RF then refer to the 2D setup chart starting on page 24.

1. To configure your reader using the RF Laser Setup Menu, you must first scan the Start Setup code at the

top left corner. Do this now. You'll hear two beeps. During Setup, nothing will be transmitted to your

computer; the Reader Setup Menu codes are strictly for configuring the reader. If you did not hear two

beeps, try scanning the code again, until you hear the two beeps. If you've never scanned bar codes before,

read the scanning instructions on page 6 before continuing. The scanner LED will turn green when in

setup mode.

2. Next, choose the setting you want to change an option for and scan its code. You will hear 2 beeps each

time you read a setup barcode.

3. Then, choose the option you want to change, from the list next to the setting bar code you just scanned.

Using the "Barpad Table" on the right side of the Reader Setup Menu, scan the number or letter associated

with the option you have selected to change. Some settings (like Preamble and Postamble) require the

SET barcode to terminate a string entry but most are single character.

4. Now scan End Setup (at the top-right corner of the Reader Setup Menu to complete the setup. You'll hear

three beeps.

The next several pages will show you all of the various Wireless Reader options. Default settings are shown

in bold in this manual and marked with an * on the Reader Setup Menu.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 72 73

Sem comentários

Worth Data LZ404-RF Guia de Configuração Página 12