Worth Data LZ404-RF Guia de Configuração descarregar pdf (Página 7)

Installation

Components of RF Laser Readers

In the event the shipping box shows damage on arrival, please note the damage on the carrier's receipt log.

The standard contents of your reader shipment are the following:

1. One or more RF Laser scanners.

2. USB Base Station receiver.

3. A Worth Data regulated 5V power supply to charge the RF Laser Scanner. TO PREVENT DAMAGING

THE RF LASER, DO NOT USE ANY OTHER BRAND OF POWER SUPPLY.

4. A CD with the user’s manual and setup sheet pdf files.

RF Laser Battery Charging

Before using the RF Laser it is a good idea to fully charge the battery. Simply plug the Worth Data charger

into the base of the RF Laser handle. The red LED should turn on to indicate that the battery is being charged.

If the red LED does not light then either the battery is already fully charged or the battery or charger is

defective. It takes about 3 hours to fully charge the battery. The 1D RF Laser will read about 30,000 bar

codes per charge and the 2D RF Laser will read about 15,000 bar codes per charge.

If you pull the trigger and the LED is RED instead of YELLOW during scanning then the battery is below

10% and will need to be charged soon.

USB Base Station Receiver Installation

You can plug the USB Base Station receiver into any USB port on your computer. The USB Base Station will

automatically be sensed and the driver installation will begin. Windows can usually find the necessary driver

on the hard drive under /Windows/System 32/Drivers; occasionally you will have to insert the original

Windows CD. The Mac always finds the driver. In either case, the driver used is the standard USB keyboard

driver. No special drivers are required. The LED on the USB Base Station will turn red during enumeration

then turn green after successful USB-HID keyboard enumeration.

You can toggle the USB Base Station enumeration between USB-HID (keyboard) and USB-CDC (com port)

by pressing and holding the button on the USB Base Station for 6 seconds. After about 2 seconds the LED

will blink red 3 times. Continue to hold the button down until the LED blinks green 3 times then release the

button. Your computer should report “New hardware found” and ask for a driver. An INF file is included on

the supplied driver CD that will install the necessary drivers. The LED on the USB Base Station will turn red

during enumeration then turn yellow after successful USB-CDC enumeration.

The interface type (keyboard or com port) is stored in the USB Base Station receiver so if you unplug the

receiver or power cycle your computer the receiver will maintain the interface type.

USB-CDC operation is supported under Windows XP, Vista and 7 for both 32-bit and 64-bit versions.

If you mistakenly abort your driver installation, see the Trouble Shooting Section of this manual.

1 2 3 4 5 6 7 8 9 10 11 12 ... 72 73

Comentários a estes Manuais

Sem comentários

Nikon MB-D100 Instrukcja Użytkownika (4 strony)

Marka: Nikon | Kategoria: Photo Accessories | Rozmiar: 4.72 MB |

Spis treści

6MAK1076-02

Eingebautes

Mikrofon

Français

Nederlands

Italiano

Więcej produktów i instrukcji dla Akcesoria fotograficzne Nikon

Modele	Rodzaj dokumentu
AF-S VR	Instrukcja Użytkownika Nikon AF-S VR User Manual, 71 strony
EN EL4	Instrukcja Użytkownika Nikon EN EL4 User Manual, 2 strony
Super Coolscan 5000 ED	Instrukcja Użytkownika Nikon Super Coolscan 5000 ED User Manual, 2 strony
AF ZOOM-NIKKOR AFF3AF	Instrukcja Użytkownika Nikon AF ZOOM-NIKKOR AFF3AF User Manual, 2 strony
AF-S DX NIKKOR 18-55mm f/3.5-5.6GVR ED	Instrukcja Użytkownika Nikon AF-S DX NIKKOR 18-55mm f/3.5-5.6GVR ED User Manual, 104 strony
50mm f/1.4G	Instrukcja Użytkownika Nikon 50mm f/1.4G User Manual, 100 strony
SK-9	Instrukcja Użytkownika Nikon SK-9 User Manual, 1 strony
Multi-Power Battery Pack G02	Instrukcja Użytkownika Nikon Multi-Power Battery Pack G02 User Manual, 332 strony
AF Zoom-Nikkor	Instrukcja Użytkownika Nikon AF Zoom-Nikkor User Manual, 2 strony
COOLSCAN IV ED	Instrukcja Użytkownika Nikon COOLSCAN IV ED User Manual, 2 strony
AF-S DX VR Zoom-Nikkor 55-200mm f/4-5.6G IF-ED	Instrukcja Użytkownika Nikon AF-S DX VR Zoom-Nikkor 55-200mm f/4-5.6G IF-ED Benutzerhandbuch, 2 strony
SD-9	Instrukcja Użytkownika Nikon SD-9 User Manual, 155 strony
35mm SLR	Instrukcja Użytkownika Nikon 35mm SLR User Manual, 2 strony
EN-EL8	Instrukcja Użytkownika Nikon EN-EL8 User Manual, 2 strony
AF Nikkor 18mm f/2.8D	Instrukcja Użytkownika Nikon AF Nikkor 18mm f/2.8D User Manual, 2 strony
AF Nikkor 85mm f/1.4D IF	Instrukcja Użytkownika Nikon AF Nikkor 85mm f/1.4D IF User Manual, 2 strony
ONESHOT360 360TM	Instrukcja Użytkownika Nikon ONESHOT360 360TM User Manual, 2 strony
AF-S DX	Instrukcja Użytkownika Nikon AF-S DX User Manual, 2 strony
AF-S DX	Instrukcja Użytkownika Nikon AF-S DX User Manual [en] , 104 strony
28-200mm f/3.5-5.6D IF	Instrukcja Użytkownika Nikon 28-200mm f/3.5-5.6D IF User Manual, 2 strony

Worth Data LZ404-RF Guia de Configuração Página 7

Comentários a estes Manuais

Nikon MB-D100 podręczniki

Nikon MB-D100 Instrukcja Użytkownika (4 strony)

Spis treści

Więcej produktów i instrukcji dla Akcesoria fotograficzne Nikon

Worth Data LZ404-RF Guia de Configuração Página 7

Comentários a estes Manuais

Manuais e produtos relacionados com Leitores de códigos de barras Worth Data LZ404-RF

Nikon MB-D100 podręczniki

Nikon MB-D100 Instrukcja Użytkownika (4 strony)

Spis treści

Więcej produktów i instrukcji dla Akcesoria fotograficzne Nikon